Thursday, December 21, 2017

Benjamin Fulford -- December 21st 2017: Letter to the Editor – Experimental Quantum Anti-Gravity Successfully Replicated


Hello, and warm greetings.
                       
I would like to let you know that my anti-gravity experiments have been successfully replicated by the Aerospace Engineering Department at the New Sciences & Technologies Faculty of the University of Tehran in the Islamic Republic of Iran.  



Related Official? -- Covert Disclosure of Antigravity Craft near MacDill AFB

Source - Benjamin Fulford

I have developed complete quantum anti-gravity hypothesis,  
which makes direct testable predictions that are simple, 
clear, easy, and inexpensive. 
                                 
As you know, present day quantum gravity theories 
suffer from too many mathematical space dimensions,
and from too few conclusive experimental results. 
My hypothesis is simple, clear, and subject to easy empirical verification. I offer clear explanation of the principles of quantumanti-gravity,
and also precisely describe how to perform simple
and inexpensive experiments to verify it.   
                        
                    

In order to clearly understand quantum anti-gravity, please follow these 8 steps:

  1. Start from this brief overview — Quantum Gravity in a Nutshell

  2. The theoretical basis for quantum gravity are the Abraham’s equations of the Abraham-Minkowski controversy, and their empirical counterpart — the Abraham force

  3. To understand how the Biefeld-Brown effect works, you need to be clear where B-B vectors point — “up” or “down”

  4. The Biefeld-Brown effect is an instance of the Abraham force

  5. Study the section about gyroscope’s anomalous effect

  6. Please, study all the material on THE BOYD BUSHMAN EFFECT page in order to appreciate the potential complex magnetic fields have for shaping quantum gravity interactions

  7. Now, you are ready to read short introduction to quantum gravity

  8. Perform two simple experiments for empirical verification

                                 
The following are the 10 “mysteries” that my hypothesis sheds new light upon:
  1. The main prediction of my hypothesis (2016) is that anti-hydrogen will anti-gravitate ;

  2. Gravitational waves  mystery ;

  3. EmDrive  mystery ;

  4. Solar  mystery ;

  5. Mass  mystery ;

  6. Bicycle  mystery ;

  7. Propeller  mystery ;

  8. Cloud  mystery ;

  9. Pioneer  mystery ;

  10. Missing  mystery.              

I have designed 4 progressively more complex experiments, 
and we have successfully performed one of them,
the one of medium difficulty, which constitutes:        
          
The empirical discovery of hitherto unknown physical interaction 
between angular momentum of a spinning gyroscope 
and Earth’s magnetic and electric fields.  
                                 
To perform this experiment we need a gyroscope with a vertical support, 
and a magnetic and electric shielding cages. 
                  
According to my hypothesis, there will be a measurable time difference 
between a freely spinning gyroscope inside, and outside the cages.  
                 
A gyroscope freely spinning inside both cages will come to rest 
in less time than when spinning outside them.




The experiment was performed successfully 
by an experienced professional electrical engineer, 
and was recorded in the following two videos  —  
To have a clear idea what is involved in the experiment, 
please take a closer look at the above two videos first. 
                              
For the experiment we used the following small, 
and light, gyroscope at 10,000 rpm : 
It would be much better to use a heavier gyro,  
because the heavier the gyro,  the stronger the effect, 
at the same rate of rpm.
     
The value of angular velocity (rpm) is important only in so far 
as to generate sufficient angular momentum to allow the gyro 
to spin freely for a longer time before it comes to rest. 
          
The objective of the experiment was to obtain two values 
of the gyro’s run time:  
  • outside the shielding ; 
  • inside the shielding.
In my experiment the two sample values are respectively:  
  • 55.54 seconds ; 
  • 51.87 seconds. 
There was a 3.67 seconds difference, which amounts to 6.6 %  

                      
The time difference is directly proportional to the quality 
and quantity of electrostatic shielding of the Faraday cage. 
Applying the magnetic shielding in addition to the electric one 
would further increase the time difference.  
                   
As you can see in the video, it is important that the gyro is elevated 
by means of a vertical support. Ideally, gyro should start spinning 
as close to a vertical position as possible, and also be able to pass lower, 
while still spinning, than its horizontal position.   
The reason for this effect is that the gyroscope inside the cages 
will be spinning in reduced strength of Earth’s magnetic and electric fields, 
which in turn reduces the strength of the Biefeld-Brown effect acting upon it.
   
The gyroscope outside the cages, spinning in the undiminished strength of Earth’s magnetic and electric fields is subject to the full influence of the Biefeld-Brown effect that causes the gyroscope to resist Earth’s gravity pull, which happens to be none other than pure natural antigravity effect.
OBJECTIONS
  • All conductors, like the brass gyro, exhibit an effective diamagnetism when they experience a changing magnetic field. The Lorentz force on electrons causes them to circulate around forming eddy currents. The eddy currents then produce an induced magnetic field that opposes the applied field and resist the conductor’s motion.

—  That is true for both, the gyro spinning inside and outside the Faraday cage in Earth’s magnetic field. It does not make any difference.

  • But gyro’s induced magnetic field will generate eddy currents in the Faraday cage and the resultant magnetic field will slow down gyro’s spin (magnetic breaking), and hence the whole effect. It is like dropping a magnet down a copper pipe:  


—   Analogy in the video applies, but only in principle. Spinning brass gyro is not a strong neodymium magnet, and if, in principle, it generates any magnetic field, it is so weak that it will not even affect a needle of a compass. As opposed to the copper pipe in the video, the enamel-coated copper mesh Faraday cage has much larger diameter (the inverse-square law), so it is enough to drop a strong neodymium magnet down the Faraday cage to see how much it would slow down, if at all. As you can see in the above video, even few empty slits in the copper pipe greatly weaken the eddy currents, this being the reason for using enamel-coated copper mesh. Diamagnetic materials, like brass, or copper, have a relative magnetic permeability that is less than or equal to 1, and therefore a magnetic susceptibility less than or equal to 0, since susceptibility is defined as χv=μv−1. This means that diamagnetic materials,  in principle, are repelled by magnetic fields. However, since diamagnetism is such a weak property, its effects are not observable in everyday life. Moreover, there is a big difference between Faraday cage made of solid copper, and one made of enamel-coated copper mesh. The magnetic field induced in the gyro is weak, because Earth’s magnetic field is weak, so whatever little eddy currents could be induced by the gyro in solid copper Faraday cage will become irrelevant in the enamel-coated copper mesh Faraday cage, as you can see in the following two videos: 





CONCLUSION   

Even though it is true that the experiment, in principle, is open to influences from various phenomena, including the Carnegie curve, the overall result is clearly well beyond being attributed exclusively to these other phenomena. To completely eliminate above objections, magnetic shielding needs to be applied in addition to the Faraday cage, and the gyro should be custom-made from a material which does not allow for eddy currents to flow in it.                 
Naturally,  I will be happy to answer any questions 
that you may have for me regarding the theoretical foundations  
of my hypothesis, as well as replication of the experiment

With respect and much gratitude,  I am
Sincerely yours,

_________________________
Stillness in the Storm Editor's note: Did you find a spelling error or grammar mistake? Do you think this article needs a correction or update? Or do you just have some feedback? Send us an email at sitsshow@gmail.com with the error, headline and urlThank you for reading.
________________________________________________________________
Question -- What is the goal of this website? Why do we share different sources of information that sometimes conflicts or might even be considered disinformation? 
Answer -- The primary goal of Stillness in the Storm is to help all people become better truth-seekers in a real-time boots-on-the-ground fashion. This is for the purpose of learning to think critically, discovering the truth from within—not just believing things blindly because it came from an "authority" or credible source. Instead of telling you what the truth is, we share information from many sources so that you can discern it for yourself. We focus on teaching you the tools to become your own authority on the truth, gaining self-mastery, sovereignty, and freedom in the process. We want each of you to become your own leaders and masters of personal discernment, and as such, all information should be vetted, analyzed and discerned at a personal level. We also encourage you to discuss your thoughts in the comments section of this site to engage in a group discernment process. 

"It is the mark of an educated mind to be able to entertain a thought without accepting it." – Aristotle

The opinions expressed in this article do not necessarily reflect the views of Stillness in the Storm, the authors who contribute to it, or those who follow it. 

View and Share our Images
Curious about Stillness in the Storm? 
See our About this blog - Contact Us page.

If it was not for the gallant support of readers, we could not devote so much energy into continuing this blog. We greatly appreciate any support you provide!

We hope you benefit from this not-for-profit site 

It takes hours of work every day to maintain, write, edit, research, illustrate and publish this blog. We have been greatly empowered by our search for the truth, and the work of other researchers. We hope our efforts 
to give back, with this website, helps others in gaining 
knowledge, liberation and empowerment.

"There are only two mistakes one can make along the road to truth; 
not going all the way, and not starting." — Buddha

If you find our work of value, consider making a Contribution.
This website is supported by readers like you. 

[Click on Image below to Contribute]


Support Stillness in the Storm